Description
Single component enamel ALURONAL based on synthetic polymer and zinc powder.
Scope and specifics of application
Aluronal enamel is used for steel products and structures long-term corrosion protection. It has high weather-resistant, anticorrosive, wear proof properties as well as a good decorative effect. The aluminum powder contained in the enamel improves coating protective properties due to the barrier effect.
It is used for anticorrosive protection of metal pipes and steel structures, for painting steel and water tanks, power line supports, hangars, galvanized roofs and domes, pipelines and oil and gas pipelines, bridges and hydraulic facilities, metal platforms, overpasses and floating docks as well as any metal structures operated in water-saline mist conditions.
Information on the material resistance to various media is available on request.
Main fields of application: capacitive equipment, transport construction, power engineering, railway transport facilities, oil and gas facilities.
Instruction for use
Primed surface should be free of grease before coating. Use as a degreaser water-based cleansing agents with pH 6-8. Dry the surface. Don't use solvents as degreasers!
Conditions
Basis temperature higher than dew point no less than 3°C.
Ambient temperature from -10°С to +35°C.
Relative air humidity no more 80%.
The process of applying
|
Preparation |
Ready to use. Stir thoroughly before use with mixer. Thin if needed with formula thinner RP-1K, RP-1K F. Should be mixed while operating.
|
| Air-free spraying |
Thinning: 0-5% The diameter of the nozzle: 0,011-0,017" Initial pressure: 120-160 ATM |
| Air spraying |
Operational viscosity: 30-60 s Thinning: 5-10% Nozzle diameter:1,8-2,5 mm Initial pressure: 3,0-4,0 atm |
| Cross linking at 200С |
10-20 min
|
|
Roller Brush |
Can be recommended for small and hard-to-reach areas. Thin the primer-enamel depending on the working conditions when using brush. |
|
Thinner |
Formula thinner RP-1K, RP-1K F. |
|
Cleaner |
Formula thinner RP-1K,Р-4, RP-1K F. |
|
Finishing |
Tubing, pistol and other spraying tools must be cleaned after using. |
|
Cleaning |
Wash the tools after using immediately. The frequency of washing depends on the amount of sprayed material, the temperature and the time since the shutdown, including any time lag. |