Description
Single component acrylic fast-drying enamel.
Scope and specifics of application
Enamel ALURONATHQ it is intended for painting a pre-primed surface in order to create highly decorative finishing coatings.
It is used to paint metal surfaces in the reduced drying mode, including assembly painting. It is used for anti-corrosion protection of internal and external surfaces of vehicles (agricultural machinery, construction equipment, public transport, railway transport), machine parts and mechanisms, construction metal structures surfaces, containers, hangars, roofs as well as other metal products exposed to increased mechanical and atmospheric effects. ALURON primer-enamel is used as repair coating as well as finishing products after assembly both indoor and outdoor. For these purposes, the material can be packaged into aerosol cans.
Information on the material resistance to various media is available on request.
Main fields of application: powerу engineering, mechanical engineering, railway transport facilities.
Instruction for use
The surface to be painted must be primed. The base prepared for applying enamel should be dry, free of grease, salts and other contaminants.
Conditions
Relative air humidity no more 80%.
The process of applying
|
Preparation |
Ready to use. Stir thoroughly before use with mixer. Thin if needed with formula thinner RP-1K, RP-1K F. |
| Air spraying |
Operational viscosity: 18-25 s Thinning: RP-1К Nozzle diameter:1,6-1,8 mm Initial pressure: 0,3-0,4 atm |
|
Air free spraying |
Thinning: 0-20% The diameter of the nozzle: 0,015-0,017" Initial pressure: 120-160 ATM |
| The process of application from the aerosol can |
Shake the aerosol can thoroughly, remove the cap. Press the spray head and apply the primer-enamel to the surface prepared for painting with uniform movements. After painting, clean the spray valve, turn the cylinder over and press the spray head until the release of the remaining primer enamel stops.
|
| Cross linking at 200С |
30 min
|
|
Thinner |
Formula thinner RP-1K, RP-1K F. |
|
Cleaner |
Formula thinner RP-1K, P-4, RP-1K F. |
|
Finishing |
Tubing, pistol and other spraying tools must be cleaned after using. |
|
Cleaning |
Wash the tools after using immediately. The frequency of washing depends on the amount of sprayed material, the temperature and the time since the shutdown, including any time lag. |